8 Signs Your Sprinkler System Needs Repair, and What They Mean
The most common signs your sprinkler system needs repair are soggy spots that never dry, brown patches in an otherwise green lawn, a zone that will not turn on or will not shut off, heads that mist, gush or do not pop up, and a water bill that jumps without explanation. Spring is when most of these show up, because the system sat idle all winter and freezes may have cracked parts.
This guide goes through the eight signs, explains what usually causes each one, lists what you can safely check yourself and when it is time for a repair visit.
Why do sprinkler problems show up in spring?
Because the system sat unused and exposed to cold, and nobody watched it run for months. Small leaks, shifted heads and dead controller batteries are all found the first time the water goes back on.
- Freezes can crack heads, fittings and the backflow preventer
- Mowers, cars and foot traffic knock heads out of line over the year
- Grass and soil grow over heads that sit too low
- Roots can crush or invade shallow pipe
- Controllers can lose their programs during power outages
Run each zone one at a time on the first warm day and watch it. Most problems are obvious within a few minutes.
What does a soggy spot or a geyser mean?
It usually means a broken pipe, a cracked fitting or a head that has snapped off. Water takes the easiest path out, so a break shows as a wet area, a sunken spot or a fountain of water.
- A geyser where a head should be: the head or its riser is broken
- A spot that stays wet days after watering: a leak underground
- Water bubbling from the soil when the zone runs: a cracked pipe or fitting
- A low area that keeps sinking: soil being washed away by a slow leak
Turn off that zone until it is fixed. A leak left running wastes water and can soften the ground near walks and foundations.
Why are there dry, brown patches in a watered lawn?
Usually because water is not reaching that area. Coverage problems are among the most common reasons for patchy lawns in irrigated yards.
- A broken sprinkler head that no longer sprays
- A head tilted, sunk or blocked by grass and soil
- A nozzle clogged with dirt or debris
- Sprays aimed at the driveway instead of the lawn
- Heads spaced too far apart for the nozzle size
Low water pressure in a sprinkler zone can also leave gaps, because the spray does not reach as far as it was designed to.
What does it mean when a zone will not turn on or will not stop?
It usually points to the valve, the wiring or the controller. A sprinkler zone not turning on and a zone that runs constantly are different symptoms with related causes.
- Zone will not start: a failed solenoid, a cut wire, a programming error or a closed flow control on the valve
- Zone will not stop: debris holding the valve open, a worn diaphragm or a stuck solenoid
- Water seeping from a valve box: a sprinkler valve leaking at its seals or fittings
- Several zones failing at once: often the controller, its transformer or a shared common wire
If a zone will not shut off, close the main irrigation supply valve until it can be repaired.
Why is the water bill higher than usual?
A sudden increase with no change in your watering schedule often means a hidden leak. Underground breaks and valves that weep between cycles can waste a lot of water without being seen.
- Compare the bill with the same month last year
- With all water off in the house and the system, check whether the meter still moves
- Walk the yard looking for spots greener or wetter than the rest
- Check the controller for extra start times or a zone set far too long
What can you check yourself before calling for repair?
Simple adjustments are fine for most homeowners. Leave digging near pipes, valve rebuilding, wiring and anything on the backflow preventer to someone with the right training.
- Check the controller's date, time, program and batteries
- Make sure the rain sensor is not holding the system off
- Clear grass and soil from around heads and rinse clogged nozzles
- Straighten tilted heads and adjust spray direction away from pavement
- Replace a broken sprinkler head of the same type if you are comfortable doing so
Georgia Landscaping & Hardscaping LLC lists sprinkler system installation, maintenance and repair among its services. If your system was shut down for winter as described in the guide to winterizing a sprinkler system in Georgia, spring is a natural time for a check. Its page on landscaping in Kennesaw, GA describes the work it does in Cobb County.
Frequently asked questions about sprinkler repair
How do I know if a sprinkler valve is bad?
Common signs are a zone that will not turn on, a zone that will not shut off, or water seeping into the valve box. Checking the controller and wiring first helps rule out other causes before replacing the valve.
Why do my sprinkler heads not pop up?
Low pressure, debris in the head, a stuck seal or a leak elsewhere in the zone can keep heads from rising. Heads buried by grass and soil may also stay down. Try cleaning one head; if the whole zone is weak, look for a leak.
Can a sprinkler system be repaired or does it need to be replaced?
Most problems are repairs: heads, nozzles, valves, wires or a section of pipe. Replacement or redesign is usually considered only when the system is old, poorly laid out or no longer matches the landscape.
How often should a sprinkler system be inspected?
A check when it is turned on in spring and a look during the hottest part of summer catch most problems. Watching each zone run for a minute or two a few times a season is a good habit.
Get your sprinklers checked by Georgia Landscaping & Hardscaping LLC
Georgia Landscaping & Hardscaping LLC is a landscaping and hardscaping company based in Marietta, GA that offers sprinkler system installation, maintenance and repair, irrigation systems, sod installation and landscape design. It serves Marietta, Kennesaw, Acworth, Roswell, Smyrna and Atlanta. To have your system looked at this spring, call 404-791-5609 or contact Georgia Landscaping & Hardscaping LLC.
